ZF-2045ZH Manual

Function of Safe

1. Fingerprint Safe: register the Fingerprint

2. Factory settings: do not register any Fingerprint

(1) Operation of opening the safe

1. Install 4 AA batteries into the external battery case, plug in the outlet on the faceplate.

2. Factory settings: do not register any Fingerprint. Put your finger to the Fingerprint reader window, to register your fingerprint. Hold the fingerprint in the Fingerprint reader window, if the Fingerprint reader window can Sensitive to finger, then the Orange color light will flash one time, you will hear beep one time also, Then Start fingerprint comparison, you will hear beep two times, the Green light on that means your fingerprint comparison successful.

If you hear beep three times means Auto-sensing failure to register your fingerprint.

If fingerprint register failure, please press the middle circle button.

Press the middle circle button, you should hear a beep, the Orange light on, the Fingerprint reader window light on also.

Put your fingerprint on the Fingerprint reader window do not move, you should hear Beep two times, the lock open, then input the key turn to open the safe.

(2) Registration the Fingerprint

1. Press the middle circle button, you should hear a beep, Fingerprint reader window light on.

2. Put your fingerprint on the Fingerprint reader window do not move, you should hear Beep one time, get your finger out from the Fingerprint reader window.

3. When the Fingerprint reader window light on again, put your same fingerprint on the Fingerprint reader window.

4. You should hear Beep two times that means the fingerprint register successful. If you hear the Beep three times that means failure. Three times registration failed the automatic exit registration status.

NOTE:

1> If Fingerprint database is full 250 fingerprint. If still have Users need to register the fingerprint, the users can consider to empty fingerprint storehouse, restore factory state.

2> Same finger registration different angles (master side, left side, right side) three fingerprint can improve the recognition rate.

(3) Delete fingerprints, return to factory default

1. Cut off the power supply first, press the middle circle button to release charge inside the capacitance.

2. Holding press the middle circle button, then plugged the power.

3. Two seconds, then loosen the middle circle button, you should hear Beep one time.Then is Beep: Beep, Beep: Beep four times that means operation successful. All fingerprint registration cleared.(For safety, it is recommended before use to remove all fingerprints.)

(4) Closed the door

Close the door, turned the key or handle to lock the door.

Cautions

1. Low charge the Red Light flash, please change the new battery in time.

2. Vibration alarm automatic enable when door is locked after 2 seconds, open the lock it automatic off.