CX-1625 Manual

1. Opening

Code setting: 1-10 digits.

Factory Setting: 123

2. OPENING THE DOOR:

First opening: insert emergency key and turn it, then turn the knob clockwise to the end, pull the door to open the safe. Then install 4 AA batteries into the interior battery case.

Now you can use the safe without the emergency key. input factory setting code, then Input correct code, then press “﹟”, at this time, you heard buzzer 2 times, “OPEN” instruction light turns green. Turn the knob clockwise to the end, pull the door.

3. CLOSING THE DOOR:

Turn the knob anti-clockwise to lock the safe directly without inputting any code.

4. CODE SETTINGS:

a. Under opening status, press the red button on the top left corner of the door (changing code switch), then, the CHG light turns yellow which indicates that it has entered into the state of changing code.

b. Input new code( within10 digits), press “﹟”. The yellow light off that indicates the code has been changed.

Note: Don’t close the door immediately after set the new code. Try the new code several times to make sure it is correct.

5. EMERGENCY OPENING:

If you forget the code or due to other reasons, please open the door by emergency key. The hole of emergency key is at the back of the panel (as picture).

6. CAUTIONS:

(1) LOW VOLTAGE:

Once the OPEN light turns red after the batteries are used for a period (about half year), it means low power. Please change them as soon as you could. (Alkaline batteries are recommended to use). If the door can not be opened as for low power, please use the external battery box.

(2) Keep the emergency key separately to insure security.